Output Angle of Attack in Aerodyn v14 / FAST v7.02

Wind & Water Computer-Aided Engineering Software Tools
#1

Hallo all,

is it possible to output the angle of attack in the linearization mode of FAST v7.02?
In FAST v8.16 it can be done by adding e.g. B1N2Alpha to the outlist in the Aerodyn15 file.
Is there something similar for Aerodyn14?

Best regards,

Simon

#2

Dear Simon,

Without modification of the source code, it is not possible in FAST v7.02 to include angle of attack as an output in the linearized model. This is because the only outputs included in the linearized model are those that are entered in the OutList section of the FAST v7 primary input file.

Best regards,