Hi,
I am working with the FAST8 Simulink interface and i am thinking about moving to OpenFAST.
As far as I can see you currently only provide a prebuild executable and the MAP.dll.
Do you plan to distribute a prebuilt OpenFAST dll in the near future?
Best,
Ole
Dear Ole,
The Simulink-FAST v8 interface has not yet been fully updated to support a Simulink-OpenFAST interface. This is an open issue in OpenFAST: github.com/OpenFAST/openfast/issues/59. That said, I know that NREL is currently working on this and I hope to see this issue resolved soon.
Best regards,
Dear Jason,
thanks for the quick answer. I will monitor the Github issue.
Best,
Ole
Dear Jason,
I have been following the issue too on GitHub. Relevant information was mentioned on OpenFAST-Simulink interface #204 github.com/OpenFAST/openfast/pull/204 15 days ago, as far as I can see, as I’m particularly interested in the issue of printing to Matlab console too.
Best regards,
Renee Degutis
Dear Renee,
Yes, hopefully OpenFAST pull request #204 should resolve this issue completely.
Best regards,