Adams linearzation analysis

Wind & Water Computer-Aided Engineering Software Tools
1

hello,everyone

I use the adams to do the linearzation in the test11.I set the ADAMSPrep=2,and get the test11.adm and test11_lin.acf,and i compile the adams2010.dll,when I run the adams for the analysis ,the warnning come up :

warnning.jpg
warnning.jpg886×218 98.2 KB

when the warnning happened,the simulation maybe stopped at 0.005s.I don,t know the why .
Hope your gudie!
BEST REGARD

Ruiliang .Wang

2

Have you solved your problem?

Maybe try to increase the tolerance or decrease the time step.

3

Hello ,everyone

In my Adams simulation ,several months ago I run the TEST11 normally by the Adams2013,I compiled the adams2013.dll,its result is right.But now I run the adams2013 to simulate the test11,the adams always shut down automally when i put the button of ‘begin to simulate’ down.I don,t know why.

This is the logaview.log (11.7 KB)
Can you help me ?
best regard
Ruiliang.Wang