Linking OpenFAST and FAST-SC with MATLAB for TMD Optimization

Dear Professor Jonkman, I hope you’re doing well.

I am currently working on optimizing the Tuned Mass Damper (TMD) parameters for the NREL reference turbine using a genetic algorithm in MATLAB.

I would like to learn how to link both OpenFAST and FAST-SC with MATLAB/Simulink to enable the optimization process.
At the moment, working with FAST-SC is more urgent for me because I have already submitted an abstract based on it, and the full paper submission deadline is approaching soon. Therefore, setting up FAST-SC with MATLAB is currently my highest priority, but I would also like to understand how to do the same for OpenFAST for future work.

Could you please guide me on how to establish this connection, or if there are any available resources or examples you could recommend?

I would really appreciate your support and advice!

Thank you so much for your time and help.

Best regards,
Anise Ziamehr

Dear @Anis.Ziamehr,

The existing interface between OpenFAST and MATLAB/Simulink does not currently support active control of Structural Controllers (StC) through Simulink. See the following OpenFAST issues for related discussion:

Best regards,